Cisco Configuration Tool

Select the Circuit Type

Client Name (Do not use spaces and include location if multi-site client):

UPLOAD SPEED (1.5m, 20m, 100m, etc.)

DOWNLOAD SPEED (1.5m, 20m, 100m, etc.)

Default Gateway (For IP Route):

ISP PRIMARY DNS

ISP SECONDARY DNS

BVI1 IP address (1st usable IP):

ISP PRIMARY AND SECONDARY DNS

Subnet Mask:

IP address (Even-side of /30 that will go on interface FastEthernet0/0):

First usable IP for client-facing range (interface FastEthernet0/1):

Subnet Mask (interface FastEthernet0/0):

IP address (interface VLAN 10)

Subnet Mask (interface VLAN 10)

IP Default-Gateway

Next hop of primary circuit (this is the core-side IP, if coming back to our core. If OoM, run traceroute to see what the next hop after the modem is):

Core-side IP address of /30 (For IP Route):

Inverse Subnet Mask (for network access-list)

Subnet Mask (interface FastEthernet0/1)

Network Address (for network access-list):

Circuit Vendor Name

Bandwidth (Mbps)

Z-loc

Voice (Yes or No)

LINE SPEED (1.5m, 20m, 100m, etc.)

CIRCUIT ID

VLAN ASSIGNMENT (use .25XX format. This will create the subinterface on fa0/0):

VLAN ASSIGNMENT (use .25XX format. This will create the encapsulation on the subinterface):

is this going to SD-WAN-1 or SD-WAN-1? (Please type the full name)

NMS Auth Key (Look at SIP trunk connection details and use the Authentication Key)

Redundant Routers (Yes or No)

Redundant Firwalls (Yes or No)

Ten digit number for e-911

Area Code for phone

Cisco Configuration Tool

Select the Circuit Type

Welcome to Cisco Configuration Tool

Select the Device from the list

Welcome to the Configuration Page!